Dake Model Trademaster - Section I User Manual download pdf (Page 8)

4/29/03

Model Trademaster Section I - 8

Lubricating

Gear Box: Your Trademaster gearbox is filled at the factory. Check the

fluid level on arrival, and then check every six months thereafter. Use 90

weight gear lube to maintain fluid level at the fill / check pipe plug.

Hydraulic Cylinder: Keep the cylinder reservoir ½ to ¾ full. Use light

hydraulic oil to refill.

Oil Cup on Variable Speed Axle: Keep full when saw is in use.

CAUTION: Fill only when machine is turned off.

Parts Installation

Some of the components of your Trademaster bandsaw have been packed separately

inside of the machine, to prevent shipping damage. Please take care when installing

these components to prevent machine damage or injury.

10 lb. Counter weight: This is used to increase or decrease cutting pressure.

1. This is to be installed on the counter weight arm. The arm is located on the right

hand side of the machine next to the speed control lever. Remove one of the cap

screws (two screws one on front and rear of this arm). Carefully slide this counter

weight onto the arm. Position it in the middle of the arm. (At the pivot point) Tighten

the lock knob on the weight. Replace the cap screw. WARNING: Never operate is

machine without these cap screws installed. The counter weight could slip off of the

arm and cause injury.

2. Speed select knob: Install on the end of the speed select lever.

1 2 3 4 5 6 7 8 9 10 11

No comments

Dake Model Trademaster - Section I User Manual Page 8